Operation instructions for pneumatic tools

Taizhou fengleiyi machinery&electronic co.,ltd. is a professional manufacturer of pneumatic tools for design, development, production, sales and service. It is located in the middle of China Gold Coastline. Water, land and air transportation is convenient, network, communication and information is developed. Of the coastal business in Zhejiang coastal city - Taizhou here is an important birthplace of China's stock cooperative economy. The company was founded in 2010, the predecessor of Taizhou Yuyu Pneumatic Tools Co., Ltd. Existing staff of more than 300 people, more than 30 professional senior technical staff.

   1, gas supply

    (1) with 90PSI (6.2Bar) clean, dry air supply tool. Excessive air pressure will quickly reduce the life of the tool.

    (2) Connect the tool to the appropriate dimensions of the parts, conduits, and hoses that are marked in the tool chart.

    (3) If an air pressure regulator is used, set the air pressure at an output pressure of 0.62 MPA.

   2, steps

    (1) Connect the pneumatic tool to the air production line.

    (2) set the air pressure.

    (3) air production line must be set up air lubricating oil device, if the air lubricants device failed or not, the tool should be the following routine maintenance:

    A. After working continuously for 3 to 4 hours, separate the tool from the air supply and drop 7-8 drops of high purity light oil (low viscosity) from the tool inlet and connect the air pipe to open the air supply and blow the oil Into the cylinder. Conditional users and the work intensity is full of load, it is recommended to install a small oil filler at the inlet.

    B. Usually 30-40 days of air compressors and oil and water separator for regular drainage, in addition to impurity maintenance, to ensure that the air into the tool clean and dry.