Use of wind gun and maintenance

At present, the main production of industrial-grade assembly of pneumatic tools, is committed to the production industry, cutting-edge products, including professional-level specifications of the gun wind approved, wind guns, especially oil-type, hydraulic pulse pneumatic tools is the industry's cutting-edge products. The company's products are mainly used for automobile, motorcycle, electric car, bicycle assembly and maintenance of motor engines, generators, agricultural machinery, air compressors, small machinery and other products for the assembly of the world's automotive, pipe, ship and other industrial manufacturing and automotive After-sales service market widely used, and exported to Europe and the United States and the Middle East and other countries.

   The wind gun is a pneumatic tool, because it works when the noise is relatively large, such as guns, hence the name, also known as pneumatic wrench. Its power source is the air compressor output compressed air, when the compressed air into the air gun cylinder after the impeller inside the rotation and produce rotation power. The impeller then drives the striking portion of the striking portion to perform a hammer-like movement, tightening or removing the screw after each knock. It is a highly efficient and safe tool for disassembly of screws.

   The angle of the gun is like a gun, a 1/2 pneumatic wrench, which means that the square portion of the connecting sleeve is 0.5 inches long. This is a relatively small wind gun, suitable for trolley tires on the screws. 1 inch square head, generally suitable for relatively large points on cars, trucks, on the bus. The large wind gun produces the equivalent of two adults with two meters long wrench hard to tighten the power of the screw is also large, its strength is usually proportional to the pressure of the air compressor, the pressure generated The strength of the large, and vice versa is small. So once the pressure is too large, tighten the screws when the screws easily damaged.

    The internal structure of the wind gun is divided into single hammer, double hammer, three hammer, four hammer, double hammer structure, single hammer without pin structure. Now the main structure of the double-ring structure which is mainly used in small wind gun, because the structure of the torque generated by a single hammer is much larger, while its material requirements are relatively high. If this structure is applied to a large wind gun, then its blow block (hammer) is very easy to crack. Large wind gun its main structure is a single hammer without a pin structure. This structure from the fight to fight that is currently the most ideal structure.

   When using the wind gun, please pay attention to the daily use of tools before and after the addition of pneumatic tools for oil. Operation or maintenance tool, please pay attention to safety protection. Make sure the tool is working under safety air pressure. Before installing, moving, adjusting the accessory or maintenance, before closing the air supply, close the air supply and disconnect the air supply pipe. Keep your stand in balance, solid, and be careful not to lose your focus. Please do not drag the trachea when moving the tool. Do not use damaged or aged air pipes and accessories. Choose the appropriate accessories. Before use, make sure that the accessories you are using are pneumatic accessories that match this pneumatic tool.